SN74LVC374ADWE4 Overview
The flip flop is packaged in a case of SOIC. Terminations are 20. The power source is powered by 1.8V. Electronic devices of this type belong to the LVC/LCX/Zfamily. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. The design is based on 8bits. Its flexibility is enhanced by 8 circuits. Due to its reliability, this T flip flop is well suited for TUBE. The D latch runs on a voltage of 3.3V volts. The D flip flop has no ports embedded. To operate, the chip has a total of 1 output lines. This input has 2lines in it. It is set to -24mAfor the high level output current. It is set to 24mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 1.65VV as its minimum supply voltage. It supports a maximum supply voltage of 3.6V volts. This frequency can be achieved 100MHz. In this case, it uses a BUS DRIVER logic IC. It is equipped with 1 functions . The D latch is equipped with 20 pins. As a result of its output current of 24mA, it is very flexible in terms of design.
SN74LVC374ADWE4 Features
20 pins
8 Bits
3.3V power supplies
1 Functions
20 pin count
SN74LVC374ADWE4 Applications
There are a lot of Texas Instruments
SN74LVC374ADWE4 Flip Flops applications.
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
- Asynchronous counter
