SN74AHCT273DBRG4 Overview
In the form of 20-SSOP (0.209, 5.30mm Width), it has been packaged. As part of the package Tape & Reel (TR), it is embedded. As configured, the output uses Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electronic component mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 4.5V~5.5V. In the operating environment, the temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. In FPGA terms, D flip flop is a type of 74AHCTseries FPGA. It should not exceed 75MHzin its output frequency. D latch consists of 1 elements. It consumes 4μA of quiescent A total of 20terminations have been recorded. If you search by 74AHCT273, you will find similar parts. The power supply voltage is 5V. This T flip flop has a capacitance of 2.5pF farads at the input. It is a member of the AHCT/VHCT/VTfamily of D flip flop. There is an electronic part that is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. This device has Positive Edgeas its clock edge trigger type. The part is included in FF/Latches. It is designed with 8bits. A reliable performance of this D flip flop makes it well suited for use in TR. The D latch operates on 5V volts. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. There are 8 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply.
SN74AHCT273DBRG4 Features
Tape & Reel (TR) package
74AHCT series
20 pins
8 Bits
5V power supplies
SN74AHCT273DBRG4 Applications
There are a lot of Texas Instruments SN74AHCT273DBRG4 Flip Flops applications.
- Shift registers
- Common Clocks
- Frequency division
- Bus hold
- Buffer registers
- Balanced 24 mA output drivers
- Guaranteed simultaneous switching noise level
- CMOS Process
- High Performance Logic for test systems
- Registers
