SN74LVC2G66DCURE4 Overview
As the electronic part is packed in 8-VFSOP (0.091, 2.30mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 8. The electronic part provides high-quality output because it has 2 channels. Powered by a 2.3V voltage supply, the electrical part should be switched on and run. The electrical component body receives 8 pins. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching with 74LVC2G66 to find analog multiplexer variants. An switch multiplexer with 10Ohm internal resistance has a value of 10Ohm. Datasheets for 8 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexers or Switches. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 1.65V. An operating current of 10μA would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 1.65V~5.5V volts. When the digital multiplexer is charged above 1μA, damage can occur. SEPARATE OUTPUT outputs are utilized by this digital multiplexer.
SN74LVC2G66DCURE4 Features
2 Channels
Switch Circuit: SPST - NO
10μA Supply Current
-3db Bandwidth: 300MHz
SN74LVC2G66DCURE4 Applications
There are a lot of Texas Instruments
SN74LVC2G66DCURE4 Analog Switches & Multiplexers ICs applications.
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
