SN74LS107AD Overview
It is embeded in 14-SOIC (0.154, 3.90mm Width) case. D flip flop is included in the Tubepackage. There is a Differentialoutput configured with it. It is configured with a trigger that uses a value of Negative Edge. There is an electronic component mounted in the way of Surface Mount. A supply voltage of 4.75V~5.25V is required for operation. A temperature of 0°C~70°C TAis used in the operation. JK Typeis the type of this D latch. The FPGA belongs to the 74LS series. In order for it to function properly, its output frequency should not exceed 45MHz. There is a consumption of 6mAof quiescent energy. Terminations are 14. This D latch belongs to the family of 74LS107. A voltage of 5V provides power to the D latch. It is a member of the LSfamily of D flip flop. Surface Mount mounts this electronic component. This board has 14 pins. This device exhibits a clock edge trigger type of Negative Edge. It is included in FF/Latches. The system runs on a power supply of 5V watts. In order to achieve high efficiency, the supply voltage should be maintained at 5V. As a result of its output current of 8mA, it is very flexible in terms of design. Currently, there are 4 input lines present. Currently, there are 2 channels available.
SN74LS107AD Features
Tube package
74LS series
14 pins
5V power supplies
SN74LS107AD Applications
There are a lot of Texas Instruments SN74LS107AD Flip Flops applications.
- Parallel data storage
- Balanced Propagation Delays
- Communications
- Frequency Divider circuits
- CMOS Process
- Set-reset capability
- Memory
- Digital electronics systems
- 2 – Bit synchronous counter
- Data storage
