SN74ALS374ADBR Overview
It is packaged in the way of 20-SSOP (0.209, 5.30mm Width). Package Tape & Reel (TR)embeds it. It is configured with Tri-State, Non-Invertedas an output. It is configured with a trigger that uses a value of Positive Edge. This electronic part is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. It is operating at a temperature of 0°C~70°C TA. It is an electronic flip flop with the type D-Type. It is a type of FPGA belonging to the 74ALS series. It should not exceed 35MHzin terms of its output frequency. D latch consists of 1 elements. As a result, it consumes 19mA of quiescent current without being affected by external factors. A total of 20terminations have been recorded. This D latch belongs to the family of 74ALS374. It is powered from a supply voltage of 5V. Devices in the ALSfamily are electronic devices. Surface Mount mounts this electronic component. As you can see from the design, it has pins with 20. This device's clock edge trigger type is Positive Edge. This part is included in FF/Latches. There are 8bits in its design. Its flexibility is enhanced by 8 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TAPE AND REEL. The D latch runs on a voltage of 5V volts. The flip flop contains 2ports. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. This input has 3lines.
SN74ALS374ADBR Features
Tape & Reel (TR) package
74ALS series
20 pins
8 Bits
5V power supplies
SN74ALS374ADBR Applications
There are a lot of Texas Instruments SN74ALS374ADBR Flip Flops applications.
- Frequency division
- Registers
- Shift registers
- Cold spare funcion
- Reduced system switching noise
- Data storage
- Instrumentation
- Frequency Divider circuits
- Convert a momentary switch to a toggle switch
- Data transfer
