MAX4597DBVR Overview
Shipping overseas is convenient due to the electrical component's packing in SC-74A, SOT-753. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature around -40°C~85°C TA extended. Total terminations are 5. A high-quality output is provided by the electrical component's 1 channels. Powered by a 3V voltage supply, the electrical part should be switched on and run. A key feature of the 5 series is the inclusion of this electronic part as part of its design. The analog switch ics are built using SPST - NC switching circuits. If you are looking for variants of the digital switch, trying search with MAX4597. A 10Ohm internal resistance characterizes this multiplexer. Datasheets for 5 pin functions are available upon request. The analog multiplexer shown here is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. Analogue multiplexer with a Single supply type that is cost-effective. It is recommended to use 2V as the lowest voltage for the electrical part. An operating current of 1μA would be sufficient for this switch device. An analogue multiplexer drains from a single voltage supply at 2.4V~5.5V. A voltage higher than 1μA may cause damage to the switch multiplexer. 300MHz bandwidths enable data to be transferred.
MAX4597DBVR Features
1 Channels
Switch Circuit: SPST - NC
1μA Supply Current
Bandwidth: 300MHz
MAX4597DBVR Applications
There are a lot of Texas Instruments MAX4597DBVR Analog Switches & Multiplexers ICs applications.
- DSLAMs
- RGB switches
- PBX interfaces
- Sample-and-hold systems
- Cellular phones
- PCMCIA cards
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Fiber In The Loop (FITL)
- USB 1.1 signal switching circuits
- Audio and video routing
