CD74HCT173MT Overview
The package is in the form of 16-SOIC (0.154, 3.90mm Width). As part of the package Tape & Reel (TR), it is embedded. Currently, the output is configured to use Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. The supply voltage is set to 4.5V~5.5V. A temperature of -55°C~125°C TAis used in the operation. D-Typeis the type of this D latch. The FPGA belongs to the 74HCT series. A frequency of 60MHzshould not be exceeded by its output. There are 1 elements in it. Currently, there are 16 terminations. D latch belongs to the 74HCT173 family. An input voltage of 5Vpowers the D latch. A JK flip flop with a 10pFfarad input capacitance is used here. Devices in the HCTfamily are electronic devices. There is an electronic part that is mounted in the way of Surface Mount. The 16pins are designed into the board. There is a clock edge trigger type of Positive Edgeon this device. This device has the base part number FF/Latches. An electronic part with 4bits has been designed. Due to its superior flexibility, it uses 4 circuits. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. It operates from 5V power supplies. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. Featuring the maximum design flexibility, it has an output current of 6mA . There are no output lines on the JK flip flop. Quiescent current is consumed by the D latch in the amount of 8μA. WITH DUAL OUTPUT ENABLEis also one of its characteristics.
CD74HCT173MT Features
Tape & Reel (TR) package
74HCT series
16 pins
4 Bits
5V power supplies
CD74HCT173MT Applications
There are a lot of Texas Instruments CD74HCT173MT Flip Flops applications.
- Power down protection
- Count Modes
- Storage registers
- Balanced 24 mA output drivers
- Single Up Count-Control Line
- Parallel data storage
- Asynchronous counter
- Storage Registers
- Dynamic threshold performance
- Buffer registers
