MC100EP51DTR2G Overview
The package is in the form of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). It is included in the package Tape & Reel (TR). This output is configured with Differential. The trigger configured with it uses Positive, Negative. Surface Mountis in the way of this electric part. It operates with a supply voltage of -3V~-5.5V. -40°C~85°C TAis the operating temperature. D-Typedescribes this flip flop. In terms of FPGAs, it belongs to the 100EP series. You should not exceed 3GHzin its output frequency. During its operation, it consumes 45mA quiescent energy. Currently, there are 8 terminations. JK flip flop belongs to 100EP51 family. It is powered from a supply voltage of 3.3V. There is an electronic part mounted in the way of Surface Mount. A total of 8pins are provided on this board. This device exhibits a clock edge trigger type of Positive Edge. The part you are looking for is included in FF/Latches. There are 1bits in its design. It reaches the maximum supply voltage (Vsup) at 5.5V. If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 3V. In order to achieve its superior flexibility, 1 circuits are used. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. The system runs on a power supply of -4.5V watts. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V of the electronic flip flop. A high level output current of -50mAis set. 50mAis set as the low level output current.
MC100EP51DTR2G Features
Tape & Reel (TR) package
100EP series
8 pins
1 Bits
-4.5V power supplies
MC100EP51DTR2G Applications
There are a lot of ON Semiconductor MC100EP51DTR2G Flip Flops applications.
- Parallel data storage
- Data transfer
- Counters
- Shift registers
- Communications
- ESD protection
- ATE
- Common Clocks
- Differential Individual
- Functionally equivalent to the MC10/100EL29
