CD74HC564M96E4 Overview
In the form of SOIC, it has been packaged. There is an embedded version in the package Tape & Reel (TR). A total of 1elements are contained within it. The number of terminations is 20. An input voltage of 4.5Vpowers the D latch. In this case, the D flip flop belongs to the HC/UHfamily. There is an electronic component mounted in the way of Surface Mount. 20pins are included in its design. This device's clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. In view of its reliability, this D flip flop is a good fit for TR. The flip flop has 2embedded ports. The JK flip flop is with 3 output lines to operate. There is a consumption of 8μAof quiescent current from it. In this case, the high level output current is set to -7.8mA. 7.8mAis set as the low level output current. There should be a temperature below 125°Cduring operation. In order for the system to operate properly, the temperature should be higher than -55°C. The RS flip flop is designed to operate with a minimal supply voltage of 2VV. There is a maximum voltage support of 6V. A frequency of 60MHzcan be achieved. BUS DRIVERis the logic IC it uses. There are 1 functions available on this T flip flop. A total of 20 pins are present on this device. Its output current of 7.8mA allows for maximum design flexibility.
CD74HC564M96E4 Features
Tape & Reel (TR) package
20 pins
1 Functions
20 pin count
CD74HC564M96E4 Applications
There are a lot of Texas Instruments
CD74HC564M96E4 Flip Flops applications.
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
