CD40174BPWE4 Overview
The flip flop is packaged in TSSOP. In total, there are 1 elements. Currently, there are 16 terminations. The D flip flop is powered by a voltage of 5V . A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 16pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. As a result of its reliable performance, this T flip flop is suitable for TUBE. In terms of quiescent current, it consumes 20μA . -4.2mA is set as the high level output current. In the low level output current setting, 6.8mAis used. It is recommended that the operating temperature be below 125°C. Ideally, the operating temperature should be higher than -55°C. A minimum supply voltage of 3V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 18V. It is possible to achieve 16MHz frequencies. It uses a logic IC with a D FLIP-FLOP value. A total of 1 functions are available on the T flip flop. There are 16 pins on the D latch.
CD40174BPWE4 Features
16 pins
1 Functions
16 pin count
CD40174BPWE4 Applications
There are a lot of Texas Instruments
CD40174BPWE4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
