CD74HC377PWG4 Overview
The flip flop is packaged in 20-TSSOP (0.173, 4.40mm Width). Package Tubeembeds it. T flip flop uses Non-Invertedas the output. It is configured with a trigger that uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. It operates with a supply voltage of 2V~6V. It is operating at -55°C~125°C TA. D-Typeis the type of this D latch. This type of FPGA is a part of the 74HC series. There should be no greater frequency than 60MHzon its output. In total, it contains 1 elements. It has been determined that there have been 20 terminations. You can search similar parts based on 74HC377. An input voltage of 5Vpowers the D latch. Input capacitance of this device is 10pF farads. Electronic devices of this type belong to the HC/UHfamily. This electronic part is mounted in the way of Surface Mount. Basically, it is designed with a set of 20 pins. There is a clock edge trigger type of Positive Edgeon this device. There is a FF/Latchesbase part number assigned to the RS flip flops. It is designed with a number of bits of 8. In this case, the maximum supply voltage (Vsup) reaches 6V. A normal operating voltage (Vsup) should remain above 2V. It operates from 2/6V power supplies. In addition to its maximum design flexibility, the output current of the T flip flop is 5.2mA. This input has 8lines. As a result, it consumes 8μA of quiescent current without being affected by external factors. There is also a characteristic of WITH HOLD MODE.
CD74HC377PWG4 Features
Tube package
74HC series
20 pins
8 Bits
2/6V power supplies
CD74HC377PWG4 Applications
There are a lot of Texas Instruments CD74HC377PWG4 Flip Flops applications.
- Control circuits
- Differential Individual
- ESD performance
- Load Control
- Bus hold
- Reduced system switching noise
- ATE
- Data transfer
- Event Detectors
- Common Clocks
