SN74F112NSRG4 Overview
As a result, it is packaged as SOP. The package Tape & Reel (TR)contains it. Currently, the output is configured to use TTL. There are 2 elements in it. In 16terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The power supply voltage is 5V. It is a member of the F/FASTfamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 16. Its clock edge trigger type is Negative Edge. The flip flop is designed with 2bits. As a result of its reliability, this D flip flop is ideally suited for TR. There are 5V power supplies attached to it. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. It is designed with 1 output lines. High level output current is set to 20mA. Low level output current is set to 20mA. A temperature below 70°Cshould be used for operation. Ideally, the operating temperature should be greater than 0°C. The minimal supply voltage is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve a frequency of 130MHz. It adopts a logic IC of type J-K FLIP-FLOP. The T flip flop is equipped with 2functions . The JK flip flop has a pin count of 16. 20mA provides maximum design flexibility due to its output current.
SN74F112NSRG4 Features
Tape & Reel (TR) package
16 pins
2 Bits
5V power supplies
2 Functions
16 pin count
SN74F112NSRG4 Applications
There are a lot of Texas Instruments
SN74F112NSRG4 Flip Flops applications.
- Computers
- Communications
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
