CD74ACT175ME4 Overview
The flip flop is packaged in SOIC. In total, there are 1 elements. Currently, there are 16 terminations. The D flip flop is powered by a voltage of 5V . Devices in the ACTfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 16pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. As a result of its reliable performance, this T flip flop is suitable for TUBE. It runs on 5Vvolts of power. If high efficiency is desired, the supply voltage should be kept at 5V. In terms of quiescent current, it consumes 8μA . -24mA is set as the high level output current. In the low level output current setting, 24mAis used. It is recommended that the operating temperature be below 125°C. Ideally, the operating temperature should be higher than -55°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 114MHz frequencies. It uses a logic IC with a D FLIP-FLOP value. A total of 1 functions are available on the T flip flop. There are 16 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 24mA.
CD74ACT175ME4 Features
16 pins
5V power supplies
1 Functions
16 pin count
CD74ACT175ME4 Applications
There are a lot of Texas Instruments
CD74ACT175ME4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
