STG3684ADTR Overview
Shipping overseas is convenient with the electronic component packed in 10-UFDFN Exposed Pad. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). The multiplexer is located in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. The operating temperature is extended to around -40°C~85°C TA. In total, there are 10 terminations. A 1 channel electronic part produces high-quality output. If the voltage supply is 2.3V volts, the electrical component should be turned on and run. It is injected into the electrical part body with 10 pins. The analog switch ics are built using SPDT switching circuits. 2 circuits are used in this analogue multiplexer. Try searching with STG3684 to find analog multiplexer variants. A 45mOhm internal resistance characterizes this multiplexer. You can find the functions of the 10 pins in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 4.3V. Analogue multiplexers of the Single supply type that are cost-effective. The lowest voltage the electronic part should receive is 1.65V. In order to operate this switch device, it would need a current of 50nA. A voltage of 1.65V~4.3V is required for this switch device, which drains from a single voltage source. If put voltage greater than 50nA on the device, damage may be caused to the analogue multiplexer. SEPARATE OUTPUT outputs are utilized by this digital multiplexer.
STG3684ADTR Features
1 Channels
Switch Circuit: SPDT
50nA Supply Current
-3db Bandwidth: 55MHz
STG3684ADTR Applications
There are a lot of STMicroelectronics STG3684ADTR Analog Switches & Multiplexers ICs applications.
- Signal routing between systems
- High reliability control systems
- Microprocessor Controlled Analog Systems
- Intelligent PBX
- ATM
- Central office
- Multiplexers
- Cable PC
- DSUs
- Automotive applications
