BA3474FVJ-E2 Overview
A 14-TSSOP (0.173, 4.40mm Width) case is used to package the op amp. The instrumentation amplifier in this picture is of the General Purpose-type. The op amp is delivered to you in a Tape & Reel (TR) case. The number of terminations approaches 14. I would like to remind you that this buffer op amp should be powered by an 15V battery. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. There are 14 pins on this chip. As far as the input offset voltage is concerned, linear amplifier rates at 1.5mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~85°C . As long as the supply current of the chip does not exceed 8mA, this op amp ic can operate. This op amp ic has 4 circuits. This linear amplifier pack is based on the TAPE AND REEL axis. A voltage gain of 10000 is the minimum this op amp can achieve.
BA3474FVJ-E2 Features
supply voltage of 15V
BA3474FVJ-E2 Applications
There are a lot of ROHM Semiconductor BA3474FVJ-E2 Instrumentational OP Amps applications.
- Portable electronic products powered by batteries
- Industrial control system
- Industrial applications including automation
- Test equipment
- Weighing systems
- Inverse/same-phase proportional circuit
- Image computer boards
- Fast A/D and D/A converters
- Measurements of Wheatstone bridge
- Signal operation
