NLAS4501DFT2 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 5-TSSOP, SC-70-5, SOT-353. High reliability is achieved by using advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 1:1. The operating temperature is extended to around -55°C~125°C TA. Totally, there are 5 terminations. A high-quality output is provided by the electrical component's 1 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. 5 pins are injected to the electronic part body. These analog multiplexers are built based on SPST - NO switching circuits. Try searching with NLAS4501 to find analog multiplexer variants. As far as internal resistance is concerned, it has 25Ohm. The datasheets for the 5 pins explain the functions. Multiplexer or Switches is a typical switch device. A voltage higher than 5.5V should not normally be supplied to the switches. Single supply type digital switch with a low cost. The lowest voltage fed to the electronic component should be 2V. This multiplexer would work with 1μA current. A voltage of 2V~5.5V is required for this switch device, which drains from a single voltage source. Operating voltages of 5V are compatible with the electrical part.
NLAS4501DFT2 Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
-3db Bandwidth: 220MHz
NLAS4501DFT2 Applications
There are a lot of ON Semiconductor NLAS4501DFT2 Analog Switches & Multiplexers ICs applications.
- Microprocessor controlled systems
- Precision data acquisition
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Battery-powered systems
- SONET
- DSLAMs
- Channel Banks
- Cross Connects
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Wireless Local Loop
