MC74AC273DWR2G Overview
20-SOIC (0.295, 7.50mm Width)is the way it is packaged. D flip flop is embedded in the Tape & Reel (TR) package. As configured, the output uses Non-Inverted. It is configured with the trigger Positive Edge. This electronic part is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 2V~6V. Currently, the operating temperature is -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In terms of FPGAs, it belongs to the 74AC series. You should not exceed 175MHzin its output frequency. The list contains 1 elements. This process consumes 8μA quiescents. If you search by 74AC273, you will find similar parts. The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Electronic part Surface Mountis mounted in the way. 20pins are included in its design. A Positive Edgeclock edge trigger is used in this device. The design is based on 8bits. In order to achieve its superior flexibility, 8 circuits are used. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. There are no output lines on the JK flip flop. This input has 8lines. It consumes 8μA of quiescent current without being affected by external factors. In this case, the high level output current is set to -24mA. 24mA is the low level output current. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be greater than -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 2VV. The maximum supply voltage supported by the flip flop is 6V. This frequency can be achieved at 175MHz.
MC74AC273DWR2G Features
Tape & Reel (TR) package
74AC series
20 pins
8 Bits
MC74AC273DWR2G Applications
There are a lot of ON Semiconductor MC74AC273DWR2G Flip Flops applications.
- Automotive
- Asynchronous counter
- Digital electronics systems
- Shift registers
- Clock pulse
- Instrumentation
- 2 – Bit synchronous counter
- Memory
- Bus hold
- ESCC
