74ALVC16374MTDX Overview
The item is packaged in 48-TFSOP (0.240, 6.10mm Width)cases. As part of the package Tape & Reel (TR), it is embedded. The output it is configured with uses Tri-State, Non-Inverted. It is configured with the trigger Positive Edge. This electronic part is mounted in the way of Surface Mount. The JK flip flop operates at 1.65V~3.6Vvolts. It is operating at a temperature of -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In FPGA terms, D flip flop is a type of 74ALVCseries FPGA. It should not exceed 250MHzin terms of its output frequency. A total of 2 elements are present. It consumes 40μA of quiescent The object belongs to the 74ALVC16374 family. This JK flip flop has a 6pFfarad input capacitance. In this case, the electronic component is mounted in the way of Surface Mount. This board has 48 pins. Its clock edge trigger type is Positive Edge. Flip flops designed with 16bits are used in this part. Due to its superior flexibility, it uses 16 circuits. It has 3 output lines to operate. It is reported that there are 8 input lines. It is set to -24mAfor the high level output current. 24mAis set as the low level output current. A temperature below 85°Cshould be used for operation. Ideally, the operating temperature should be greater than -40°C. In order for it to operate, a supply voltage of 1.65Vis required. In this case, it supports a maximum supply voltage of 3.6V. This frequency can be achieved 200MHz.
74ALVC16374MTDX Features
Tape & Reel (TR) package
74ALVC series
48 pins
16 Bits
74ALVC16374MTDX Applications
There are a lot of ON Semiconductor 74ALVC16374MTDX Flip Flops applications.
- Digital electronics systems
- Balanced Propagation Delays
- Modulo – n – counter
- ATE
- Frequency Dividers
- Registers
- Computers
- Synchronous counter
- Convert a momentary switch to a toggle switch
- Storage registers
