DM74ALS374WMX Overview
In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. D flip flop is embedded in the Tape & Reel (TR) package. T flip flop is configured with an output of Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electric part mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. 0°C~70°C TAis the operating temperature. This D latch has the type D-Type. It is a type of FPGA belonging to the 74ALS series. In order for it to function properly, its output frequency should not exceed 35MHz. A total of 1elements are present in it. During its operation, it consumes 19mA quiescent energy. If you search by 74ALS374, you will find similar parts. In this case, the electronic component is mounted in the way of Surface Mount. It is designed with 20 pins. A Positive Edgeclock edge trigger is used in this device. The design is based on 8bits. Due to its superior flexibility, it uses 8 circuits. In order to achieve high efficiency, the supply voltage should be maintained at 5V. It is designed with 3 output lines. Currently, there are 3 lines of input. The high level output current is set to -2.6mA. Low level output current is set to 24mA. Ideally, the operating temperature should be lower than 70°C. It is recommended that the operating temperature is higher than 0°C. The system operates with a minimum supply voltage of 4.5V. It supports the maximal supply voltage of 5.5V. It is possible to obtain a frequency of 35MHz.
DM74ALS374WMX Features
Tape & Reel (TR) package
74ALS series
20 pins
8 Bits
DM74ALS374WMX Applications
There are a lot of ON Semiconductor DM74ALS374WMX Flip Flops applications.
- Latch-up performance
- Frequency Divider circuits
- Synchronous counter
- Convert a momentary switch to a toggle switch
- Individual Asynchronous Resets
- Data Synchronizers
- Shift registers
- Supports Live Insertion
- Set-reset capability
- Bus hold
