74HCT173N,652 Overview
It is embeded in 16-DIP (0.300, 7.62mm) case. There is an embedded version in the package Tube. The output it is configured with uses Tri-State, Non-Inverted. There is a trigger configured with Positive Edge. In this case, the electronic component is mounted in the way of Through Hole. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -40°C~125°C TA. D-Typeis the type of this D latch. It is a type of FPGA belonging to the 74HCT series. This D flip flop should not have a frequency greater than 80MHz. A total of 1elements are contained within it. As a result, it consumes 4μA quiescent current. There are 16 terminations,The 74HCT173 family contains this object. The power supply voltage is 5V. A JK flip flop with a 3.5pFfarad input capacitance is used here. It is a member of the HCTfamily of D flip flop. It is included in FF/Latches. It reaches the maximum supply voltage (Vsup) at 5.5V. A power supply of 5Vis required to operate it. Additionally, there are WITH HOLD MODE on the electronic flip flop that can be referred to.
74HCT173N,652 Features
Tube package
74HCT series
5V power supplies
74HCT173N,652 Applications
There are a lot of NXP USA Inc. 74HCT173N,652 Flip Flops applications.
- Latch-up performance
- Frequency Divider circuits
- ESCC
- Balanced Propagation Delays
- Computers
- Registers
- High Performance Logic for test systems
- Digital electronics systems
- Frequency Dividers
- Safety Clamp
