MAX323EUA+ Overview
The electronic component is convenient to ship overseas because it is packed in a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). Advanced packaging method Tube is used to provide high reliability. This analog switch is mounted in Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operational temperature extended around -40°C~85°C TA. Totally, there are 8 terminations. A 1 channel electronic part produces high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. An electrical component of this type can be found in the 8 series. Circuits based on SPST - NO switching are used to construct these analog switch ics. The multiplexer consists of 2 circuits. Try searching for MAX323 variants of the analog switch ic. As far as internal resistance is concerned, it has 60Ohm. You can find the functions of the 8 pins in the datasheets. It is normally recommended that users do not supply the multiplexer with voltages higher than 16V. The digital multiplexer has a low cost Single supply. 2.7V should be the lowest voltage fed to the electronic component. This digital switch can be operated with a current of 1μA. Analogue multiplexers require a 2.7V~16V voltage to drain from a single voltage supply. If put voltage greater than 100pA on the device, damage may be caused to the analogue multiplexer.
MAX323EUA+ Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
MAX323EUA+ Applications
There are a lot of Maxim Integrated MAX323EUA+ Analog Switches & Multiplexers ICs applications.
- Signal routing between systems
- Microprocessor controlled systems
- Isolation
- Automotive applications
- Avionics test equipment
- Private Branch Exchange (PBX)
- Data Acquisition Systems
- Optical Applications
- DSUs
- Avionics and Military Systems
