ADG1311YRUZ-REEL7 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). High reliability is ensured by the advanced packaging method Tape & Reel (TR). In Surface Mount, you'll find this switch device. 1:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around -40°C~105°C TA. 16 terminations have been made so far. A 4 channel electronic part produces high-quality output. When a voltage supply of 15V is used, the electronic component should be turned on and run. An electrical component of this type can be found in the 16 series. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Look for analog switch ic variants by searching with ADG1311. Analog switches have 200Ohm internal resistance. Please refer to the datasheets for 16 pins functions. In this analog multiplexer, the value is Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 16.5V. The analog switch ic is of the Dual, Single supply type and is cost-effective. 5V should be the lowest voltage fed to the electronic component. This multiplexer would work with 220μA current. A voltage higher than 380μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 16.5VA dual power supply should have at least 5V voltage attached. The electrical part can be operated at 12V voltage levels. The data can be transferred over a wide range of bandwidths, called 600MHz bandwidths.
ADG1311YRUZ-REEL7 Features
4 Channels
Switch Circuit: SPST - NC
220μA Supply Current
Bandwidth: 600MHz
ADG1311YRUZ-REEL7 Applications
There are a lot of Analog Devices Inc. ADG1311YRUZ-REEL7 Analog Switches & Multiplexers ICs applications.
- Remote Powered Equipment
- Avionics test equipment
- Cable PC
- PDAs
- Mechanical reed relay replacement
- Wireless Local Loop
- Precision data acquisition
- Central office
- Fiber In The Loop (FITL)
- High speed data transmission line cards
