ADG1212YRUZ Overview
The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). To ensure high reliability, a new packaging method Tube is used. Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have a ratio of 1:1. The operating temperature is extended to around -40°C~125°C TA. In total, there are 16 terminations. A electrical component with 4 channels is capable of high-quality output. Turning on and running the electrical part should be easy with a 15V voltage supply. Electronic part bodies are injected with 16 pins. Multiplexers built on a SPST - NO switching circuit are built. Try searching with ADG1212 if you're looking for variants. There is 190Ohm internal resistance in this digital multiplexer. The datasheets for the 16 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 16.5V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. 5V should be the lowest voltage fed to the electronic component. A digital multiplexer may suffer damage if voltage is applied above 380μA. For this switch, a dual supply voltage is feasible, but it must not exceed 16.5VIt is recommended that you attach at least 4.5V to your dual power supply. It can operate from 12V operating voltages. A 1 GHz-bandwidth can be used for data transfer. A Drain to Source resistance of 120Ohm is shown for this electronic part.
ADG1212YRUZ Features
4 Channels
Switch Circuit: SPST - NO
Bandwidth: 1 GHz
Drain-to-Source resistance: 120Ohm
ADG1212YRUZ Applications
There are a lot of Analog Devices Inc. ADG1212YRUZ Analog Switches & Multiplexers ICs applications.
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- SDH/SONET multiplexers
- Fiber In The Loop (FITL)
- Sample hold systems
- Remote Powered Equipment
- Switching Systems
- Battery-powered systems
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Private Branch Exchange (PBX)
