DG418LDY-T1 Overview
Due to its 8-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Around -40°C~85°C TA is the extended operating temperature. 8 terminations have been made so far. A 1 channel electronic part produces high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. The electronic part body is injected with 8 pins. SPST - NO switching circuits are used in these analog switch ics. This digital multiplexer has 20Ohm internal resistance. Datasheets for functions of 8 pins are available. There is Multiplexer or Switches analog multiplexer like this in the world. Users shouldn't supply more than 12V voltage to the switch device. A analog switch ic that has a cost-effective Dual, Single supply type. 2.7V is the lowest voltage the electrical component should receive. A voltage higher than 1μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 6VA dual power supply should have at least 3V voltage attached. In order to operate the 1 inputs, there are several steps to follow. This electronic part has additional features, such as: VIDEO APPLICATION.
DG418LDY-T1 Features
1 Channels
Switch Circuit: SPST - NO
Additional Features: VIDEO APPLICATION
DG418LDY-T1 Applications
There are a lot of Vishay Siliconix DG418LDY-T1 Analog Switches & Multiplexers ICs applications.
- Remote wireless modules
- Fault Tolerant Systems
- USB 1.1 signal switching circuits
- Audio signal routing
- Multiplexers
- Automatic test equipment
- RGB switches
- Mechanical reed relay replacement
- Remote Powered Equipment
- Audio and video routing
