DG4157DL-T1-E3 Overview
The electronic component is convenient to ship overseas because it is packed in a 6-TSSOP, SC-88, SOT-363. High reliability is achieved by using advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. There is 2:1 ratio between the number of multiplexers and demultiplexers. Increasing operating temperature to around -40°C~85°C TA. A total of 6 terminations have been recorded. A 1 channel electronic part produces high-quality output. An 3V voltage supply should allow the electrical part to be turned on and run. 6 pins are injected to the electronic part body. Multiplexers built on a SPDT switching circuit are built. Look for analog switch ic variants by searching with DG4157. In this multiplexer, the internal resistance is 1.2Ohm. Please refer to the datasheets for 6 pins functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. Analogue multiplexer with a Single supply type that is cost-effective. There should be 1.65V voltage fed to the electrical part below 1.65V. It would be sufficient to run this analogue multiplexer with 50nA current. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. The switch multiplexer may be damaged if it is exposed to voltage greater than 500nA. Operating 1 inputs is required. In this digital multiplexer, there are 2 outputs.
DG4157DL-T1-E3 Features
1 Channels
Switch Circuit: SPDT
50nA Supply Current
-3db Bandwidth: 117MHz
DG4157DL-T1-E3 Applications
There are a lot of Vishay Siliconix DG4157DL-T1-E3 Analog Switches & Multiplexers ICs applications.
- Precision test equipment
- ISDN NT1/TA
- MP3 players
- Communication systems
- Transmit
- Industrial and process control systems
- Cell phones
- SONET
- Communications systems
- Isolation
