DG412DY-T1 Overview
As the electronic part is packed in 16-SOIC (0.154, 3.90mm Width), international shipping is convenient. The advanced packaging method Tape & Reel (TR) provides high reliability. It is mounted in the position Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. An extended operating temperature of -40°C~85°C TA degrees Celsius. The total number of terminations is 16. A high-quality output is provided by the electrical component's 1 channels. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. An electrical component of this type can be found in the 16 series. A SPST - NO switching circuit is used to build these analog multiplexers. It has an internal resistance of 35Ohm. For functions related to 16 pins, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage higher than 36V should not normally be supplied to the switches. Digital switch that provides Dual, Single power at a cost-effective price. It is recommended to use 13V as the lowest voltage for the electrical part. The analogue multiplexer may be damaged if voltage is greater than 1μA. For this switch, a dual supply voltage is feasible, but it must not exceed 22VFor dual power supplies, a voltage of at least 7V should be attached. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. Among the inputs that can be operated are the 4 inputs.
DG412DY-T1 Features
1 Channels
Switch Circuit: SPST - NO
DG412DY-T1 Applications
There are a lot of Vishay Siliconix DG412DY-T1 Analog Switches & Multiplexers ICs applications.
- CSU
- Digital Cross-Connects
- High reliability control systems
- PBX interfaces
- Low-Voltage
- DSUs
- Intelligent PBX
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Imaging
- Ultrasound
