DG2002DL-T1-E3 Overview
This electronic part is conveniently packaged in 6-TSSOP, SC-88, SOT-363, making it easy to ship abroad. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. There is an analog multiplexer mounted in position Surface Mount. 2:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around -40°C~85°C TA. 6 terminations have been made so far. The electronic part delivers high-quality output through its 1 channels. Powered by a 2V voltage supply, the electrical part should be switched on and run. This electronic part can be found in the 6 series. These analog multiplexers are built based on SPDT switching circuits. Look for analog switch ic variants by searching with DG2002. Analog switches have 7.8Ohm internal resistance. Datasheets for 6 pin functions are available upon request. This switch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. Analogue multiplexer with a Single supply type that is cost-effective. 1.8V is the lowest voltage that should be fed to the electronic electronic part. This digital switch can be operated with a current of 10nA. Analogue multiplexers require a 1.8V~5.5V voltage to drain from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 1μA. Among the inputs that can be operated are the 1 inputs. An output of 2 is provided by the digital multiplexer.
DG2002DL-T1-E3 Features
1 Channels
Switch Circuit: SPDT
10nA Supply Current
DG2002DL-T1-E3 Applications
There are a lot of Vishay Siliconix DG2002DL-T1-E3 Analog Switches & Multiplexers ICs applications.
- Routers
- Fault Tolerant Systems
- Industrial and process control systems
- E1 Multiplexer
- RGB switches
- Isolation
- PCMCIA cards
- PBX interfaces
- Multiplexers
- Precision test equipment
