TLV2461AMUB Overview
An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 10. The pins on this board total to 10 in total. I would like to remind you that this buffer op amp should be powered by an 3V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 10 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.5mV for this buffer op amp. 109dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 6V. A high supply voltage of more than 2.7V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 3V volts.
TLV2461AMUB Features
10 Pins
supply voltage of 3V
109dB voltage gain
TLV2461AMUB Applications
There are a lot of Texas Instruments
TLV2461AMUB Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
