TLV2461AIPE4 Overview
Packaged in a PDIP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 3V battery. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.5mV for this buffer op amp. As long as the supply current of the chip does not exceed 550μA, this op amp ic can operate. 109dB should remain the voltage gain. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 125°C should be used. The linear amplifier consists of 1 different elements in total. The operating supply voltage of the buffer op amp is rated at 3V. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 6V. A high supply voltage of more than 2.7V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 3V volts.
TLV2461AIPE4 Features
8 Pins
supply voltage of 3V
109dB voltage gain
TLV2461AIPE4 Applications
There are a lot of Texas Instruments
TLV2461AIPE4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
