TLC339IPWRG4 Overview
In order to protect the op amps, a TSSOP case is used. In the case of Tape & Reel (TR) cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 14. It consists of a total of 14 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. It has 14 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 5mV. This electronic component is recommended to be mounted using the mounting type Surface Mount. It is recommended that this op amp ic be operated at a temperature no higher than -40°C ~ 85°C for optimal performance. Buffer op amp is equipped with 4 channels on the device. As one of the many benefits of this buffer amplifier, it puts out CMOS, Open-Drain signals, which is one of the many benefits it offers. It is recommended that the temperature of this op amp ic should not fall below -55°C degrees Fahrenheit at any time. Linear amplifier shouldn't be used above 125°C degrees. As a whole, there are 4 elements that make up this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 5V. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 16V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 3V when using it. LinCMOS™ is the number that corresponds to the series of the buffer op amp. There is an 125μA quiescent current in linear amplifier.
TLC339IPWRG4 Features
14 Pins
supply voltage of 5V
Output Type: CMOS, Open-Drain
TLC339IPWRG4 Applications
There are a lot of Texas Instruments
TLC339IPWRG4 Instrumentational OP Amps applications.
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
