TLV2763INE4 Overview
Packaged in a PDIP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 2.4V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 550μV for this buffer op amp. As long as the supply current of the chip does not exceed 20μA, this op amp ic can operate. 101.58dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 3.6V. A high supply voltage of more than 1.8V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 1.8V volts.
TLV2763INE4 Features
14 Pins
supply voltage of 2.4V
101.58dB voltage gain
TLV2763INE4 Applications
There are a lot of Texas Instruments
TLV2763INE4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
