THS7001IPWPR Overview
It is packaged in an 20-PowerTSSOP (0.173, 4.40mm Width)-case that protects the operational amplifiers from damage. An op amp of this type is a Programmable Gain-type. The op amp is delivered to you in a Tape & Reel (TR) case. There have been a total of 20 terminations over the past year. A total of 20 pins are located on this board. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. In order to be more specific, this instrumentation amplifier is one of the types of Other Analog ICs devices. There are 20 pins on this chip. Op amp rates 1mV as input offset voltage. For this electronic part, it is recommended that you mount it with type Surface Mount. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~85°C for optimal performance. Operational amplifier can operate supply current at 7mA. It is a member of the 89dB's 89dB family. This op amp ic has 1 circuits. The operating supply voltage of instrumentation amplifier is rated 16V voltage. This linear amplifier also utiliANALOG CIRCUITes an analog IC known as a ANALOG CIRCUIT.
THS7001IPWPR Features
20 Pins
supply voltage of 5V
89dB voltage gain
THS7001IPWPR Applications
There are a lot of Texas Instruments THS7001IPWPR Instrumentational OP Amps applications.
- Scintillation detectors
- Fission chambers
- Inverse/same-phase proportional circuit
- Division circuits
- Automatic control
- Car stereo
- Differentiator circuits
- Multiplication circuits
- Active probe
- pH (acidity)
