SN74LVC112ADG4 Overview
The flip flop is packaged in a case of SOIC. D latch consists of 2 elements. Terminations are 16. The power source is powered by 1.8V. Electronic devices of this type belong to the LVC/LCX/Zfamily. Electronic part Surface Mountis mounted in the way. With its 16pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Negative Edge. This device is part of the FF/Latchesbase part number family. The design is based on 2bits. Due to its reliability, this T flip flop is well suited for TUBE. The D latch runs on a voltage of 3.3V volts. To operate, the chip has a total of 1 output lines. It is set to -24mAfor the high level output current. It is set to 24mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 1.65VV as its minimum supply voltage. It supports a maximum supply voltage of 3.6V volts. This frequency can be achieved 150MHz. In this case, it uses a J-K FLIP-FLOP logic IC. It is equipped with 2 functions . The D latch is equipped with 16 pins. As a result of its output current of 24mA, it is very flexible in terms of design.
SN74LVC112ADG4 Features
16 pins
2 Bits
3.3V power supplies
2 Functions
16 pin count
SN74LVC112ADG4 Applications
There are a lot of Texas Instruments
SN74LVC112ADG4 Flip Flops applications.
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
- Asynchronous counter
