SN74F74NSRG4 Overview
In the form of SOP, it has been packaged. There is an embedded version in the package Tape & Reel (TR). T flip flop uses TTLas its output configuration. A total of 2elements are contained within it. The number of terminations is 14. An input voltage of 5Vpowers the D latch. In this case, the D flip flop belongs to the F/FASTfamily. There is an electronic component mounted in the way of Surface Mount. 14pins are included in its design. This device's clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. It is designed with a number of bits of 1. In view of its reliability, this D flip flop is a good fit for TR. In order for the device to operate, it requires 5V power supplies. In order to achieve high efficiency, the supply voltage should be maintained at 5V. The number of input lines is 1. In this case, the high level output current is set to -1mA. 20mAis set as the low level output current. There should be a temperature below 70°Cduring operation. In order for the system to operate properly, the temperature should be higher than 0°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. There is a maximum voltage support of 5.5V. A frequency of 145MHzcan be achieved. D FLIP-FLOPis the logic IC it uses. There are 2 functions available on this T flip flop. A total of 14 pins are present on this device. Its output current of 20mA allows for maximum design flexibility.
SN74F74NSRG4 Features
Tape & Reel (TR) package
14 pins
1 Bits
5V power supplies
2 Functions
14 pin count
SN74F74NSRG4 Applications
There are a lot of Texas Instruments
SN74F74NSRG4 Flip Flops applications.
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
