SN74LS76ADR Overview
In the form of 16-SOIC (0.154, 3.90mm Width), it has been packaged. The Tape & Reel (TR)package contains it. It is configured with Differentialas an output. This trigger is configured to use Negative Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis required for its operation. 0°C~70°C TAis the operating temperature. There is JK Type type of electronic flip flop associated with this device. It belongs to the 74LSseries of FPGAs. It should not exceed 45MHzin its output frequency. D latch consists of 2 elements. Currently, there are 16 terminations. It is a member of the 74LS76 family. The power source is powered by 5V. This D flip flop belongs to the family of LS. There is an electronic part that is mounted in the way of Surface Mount. The clock edge trigger type for this device is Positive Edge. This part is included in FF/Latches. If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 4.75V. The D latch runs on a voltage of 5V volts. It consumes 4mA of quiescent current without being affected by external factors. In addition, you can refer to the additinal MASTER SLAVE OPERATION of the D latch.
SN74LS76ADR Features
Tape & Reel (TR) package
74LS series
5V power supplies
SN74LS76ADR Applications
There are a lot of Texas Instruments SN74LS76ADR Flip Flops applications.
- Automotive
- Asynchronous counter
- Set-reset capability
- ESCC
- Parallel data storage
- Bounce elimination switch
- Memory
- Consumer
- Frequency division
- Latch-up performance
