DM74ALS74AM Overview
It is embeded in 14-SOIC (0.154, 3.90mm Width) case. D flip flop is included in the Tubepackage. As configured, the output uses Differential. It is configured with a trigger that uses Positive Edge. Surface Mountis in the way of this electric part. It operates with a supply voltage of 4.5V~5.5V. A temperature of 0°C~70°C TAis considered to be the operating temperature. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 74ALS series. You should not exceed 34MHzin its output frequency. A total of 2 elements are present. It consumes 4mA of quiescent D latch belongs to the 74ALS74 family. There is an electronic component mounted in the way of Surface Mount. This board is designed with 14pins on it. This device has Positive Edgeas its clock edge trigger type. 2bits are used in its design. To achieve this superior flexibility, 2 circuits are used. If high efficiency is desired, the supply voltage should be kept at 5V. This T flip flop features a maximum design flexibility due to its output current of 8mA. The JK flip flop is with 1 output lines to operate. 1input lines are available for you to choose from. It is set to -400μAfor the high level output current. A 8mAvalue is set for low-level output current. Temperatures below 70°Care ideal for operating. Temperatures above 0°Cshould be used. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. It supports the maximal supply voltage of 5.5V. It is possible to obtain a frequency of 34MHz. This building block contains 2 gates as its basic building block. There are 1 inputs.
DM74ALS74AM Features
Tube package
74ALS series
14 pins
2 Bits
2 gates
DM74ALS74AM Applications
There are a lot of ON Semiconductor DM74ALS74AM Flip Flops applications.
- 2 – Bit synchronous counter
- Supports Live Insertion
- Frequency division
- Registers
- Automotive
- Storage Registers
- Consumer
- Convert a momentary switch to a toggle switch
- Load Control
- Bounce elimination switch
