SN74F574DWR Overview
The package is in the form of 20-SOIC (0.295, 7.50mm Width). There is an embedded version in the package Cut Tape (CT). The output it is configured with uses Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. Currently, the operating temperature is 0°C~70°C TA. This electronic flip flop is of type D-Type. The FPGA belongs to the 74F series. Its output frequency should not exceed 100MHz. A total of 1elements are present in it. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. If you search by 74F574, you will find similar parts. It is powered from a supply voltage of 5V. In terms of electronic devices, this device belongs to the F/FASTfamily of devices. A part of the electronic system is mounted in the way of Surface Mount. This board has 20 pins. It has a clock edge trigger type of Positive Edge. This device is part of the Bus Driver/Transceiverbase part number family. An electronic part designed with 8bits is used in this application. Due to its superior flexibility, it uses 8 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. The system runs on a power supply of 5V watts. The flip flop has 2ports embedded within it. In order to ensure high efficiency, the supply voltage should remain at 5V. Its output current of 24mAallows for maximum design flexibility. It is designed with 3 output lines.
SN74F574DWR Features
Cut Tape (CT) package
74F series
20 pins
8 Bits
5V power supplies
SN74F574DWR Applications
There are a lot of Texas Instruments SN74F574DWR Flip Flops applications.
- Patented noise
- Data transfer
- Registers
- Circuit Design
- High Performance Logic for test systems
- Automotive
- Computers
- Individual Asynchronous Resets
- Latch
- Consumer
