SN74BCT374N Overview
In the form of 20-DIP (0.300, 7.62mm), it has been packaged. The package Tubecontains it. Tri-State, Non-Invertedis the output configured for it. In the configuration of the trigger, Positive Edgeis used. There is an electric part mounted in the way of Through Hole. With a supply voltage of 4.5V~5.5V volts, it operates. 0°C~70°C TAis the operating temperature. This D latch has the type D-Type. The FPGA belongs to the 74BCT series. You should not exceed 70MHzin the output frequency of the device. D latch consists of 1 elements. During its operation, it consumes 5mA quiescent energy. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. You can search similar parts based on 74BCT374. It is powered from a supply voltage of 5V. JK flip flop input capacitance is 6pF farads. In this case, the D flip flop belongs to the BCT/FBTfamily. There is an electronic part mounted in the way of Through Hole. The 20pins are designed into the board. There is a clock edge trigger type of Positive Edgeon this device. This device is part of the FF/Latchesbase part number family. It is designed with 8bits. 8 circuits are used to achieve its superior flexibility. A total of 5V power supplies are needed to run it. A D flip flop with 2embedded ports is available. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. The 64mA output current allows it to be designed with the greatest amount of flexibility. The JK flip flop is with 3 output lines to operate.
SN74BCT374N Features
Tube package
74BCT series
20 pins
8 Bits
5V power supplies
SN74BCT374N Applications
There are a lot of Texas Instruments SN74BCT374N Flip Flops applications.
- Latch-up performance
- 2 – Bit synchronous counter
- Convert a momentary switch to a toggle switch
- Computing
- Reduced system switching noise
- Balanced Propagation Delays
- Storage registers
- ESCC
- Memory
- Latch
