SN74ALS874BDWR Overview
24-SOIC (0.295, 7.50mm Width)is the way it is packaged. The Tape & Reel (TR)package contains it. T flip flop is configured with an output of Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 4.5V~5.5V. It is operating at 0°C~70°C TA. This electronic flip flop is of type D-Type. The FPGA belongs to the 74ALS series. This D flip flop should not have a frequency greater than 30MHz. There are 2 elements in it. It consumes 21mA of quiescent It has been determined that there have been 24 terminations. You can search similar parts based on 74ALS874. The power source is powered by 5V. ALSis the family of this D flip flop. The electronic part is mounted in the way of Surface Mount. As you can see from the design, it has pins with 24. The clock edge trigger type for this device is Positive Edge. It is included in FF/Latches. An electronic part with 8bits has been designed. As a result of its reliability, this D flip flop is ideally suited for TR. The system runs on a power supply of 5V watts. The flip flop contains 2ports. The supply voltage should be maintained at 5V for high efficiency. As a result of its output current of 24mA, it is very flexible in terms of design. There are no output lines on the JK flip flop. It is also characterized by WITH CLEAR.
SN74ALS874BDWR Features
Tape & Reel (TR) package
74ALS series
24 pins
8 Bits
5V power supplies
SN74ALS874BDWR Applications
There are a lot of Texas Instruments SN74ALS874BDWR Flip Flops applications.
- Reduced system switching noise
- Convert a momentary switch to a toggle switch
- Differential Individual
- Registers
- Frequency Dividers
- Clock pulse
- Counters
- Parallel data storage
- High Performance Logic for test systems
- Synchronous counter
