SN74ALS874BDW Overview
The flip flop is packaged in a case of 24-SOIC (0.295, 7.50mm Width). You can find it in the Tubepackage. Currently, the output is configured to use Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. This electronic part is mounted in the way of Surface Mount. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. It is at 0°C~70°C TAdegrees Celsius that the system is operating. It is an electronic flip flop with the type D-Type. The 74ALSseries comprises this type of FPGA. This D flip flop should not have a frequency greater than 30MHz. D latch consists of 2 elements. It consumes 21mA of quiescent Currently, there are 24 terminations. You can search similar parts based on 74ALS874. Power is provided by a 5V supply. ALSis the family of this D flip flop. Electronic part Surface Mountis mounted in the way. This board is designed with 24pins on it. Its clock edge trigger type is Positive Edge. This device has the base part number Bus Driver/Transceiver. An electronic part with 8bits has been designed. It runs on 5Vvolts of power. This D flip flop is equipped with 0 ports. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. With an output current of 24mA, it is possible to design the device in any way you want. To operate, the chip has a total of 1 output lines. It is also characterized by WITH CLEAR.
SN74ALS874BDW Features
Tube package
74ALS series
24 pins
8 Bits
5V power supplies
SN74ALS874BDW Applications
There are a lot of Texas Instruments SN74ALS874BDW Flip Flops applications.
- Guaranteed simultaneous switching noise level
- Synchronous counter
- Pattern generators
- Instrumentation
- Single Up Count-Control Line
- Computing
- Safety Clamp
- Digital electronics systems
- Frequency division
- Patented noise
