SN74ALS574BDWRE4 Overview
As a result, it is packaged as SOIC. The package Tape and Reelcontains it. Currently, the output is configured to use TTL. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The power supply voltage is 5V. It is a member of the ALSfamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. Its clock edge trigger type is Positive Edge. The part is included in FF/Latches. The flip flop is designed with 8bits. The superior flexibility of this product is achieved by using 8 circuits. There are 5V power supplies attached to it. There are 2 ports embedded in the flip flops. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. It is designed with 1 output lines. It is reported that there are 3 input lines. High level output current is set to -2.6mA. Low level output current is set to 24mA. A temperature below 70°Cshould be used for operation. Ideally, the operating temperature should be greater than 0°C. The minimal supply voltage is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve a frequency of 35MHz. It adopts a logic IC of type BUS DRIVER. The T flip flop is equipped with 1functions . The JK flip flop has a pin count of 20. 24mA provides maximum design flexibility due to its output current.
SN74ALS574BDWRE4 Features
Tape and Reel package
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
SN74ALS574BDWRE4 Applications
There are a lot of Texas Instruments
SN74ALS574BDWRE4 Flip Flops applications.
- Computers
- Communications
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
