SN74AC574DWG4 Overview
The flip flop is packaged in SOIC. In total, there are 1 elements. Currently, there are 20 terminations. The D flip flop is powered by a voltage of 3.3V . Devices in the ACfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. As a result of its reliable performance, this T flip flop is suitable for TUBE. It runs on 3.3/5Vvolts of power. A D flip flop with 2embedded ports is available. Additionally, you may refer to the D latch's additional BROADSIDE VERSION OF 374. -24mA is set as the high level output current. In the low level output current setting, 24mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 6V. It is possible to achieve 153MHz frequencies. It uses a logic IC with a BUS DRIVER value. A total of 1 functions are available on the T flip flop. There are 20 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 24mA.
SN74AC574DWG4 Features
20 pins
3.3/5V power supplies
1 Functions
20 pin count
SN74AC574DWG4 Applications
There are a lot of Texas Instruments
SN74AC574DWG4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
