SN74AHCT74RGYR Overview
In the form of 14-VFQFN Exposed Pad, it has been packaged. A package named Cut Tape (CT)includes it. T flip flop uses Differentialas its output configuration. The trigger configured with it uses Positive Edge. Surface Mountis occupied by this electronic component. A 4.5V~5.5Vsupply voltage is required for it to operate. A temperature of -40°C~125°C TAis used in the operation. It is an electronic flip flop with the type D-Type. In terms of FPGAs, it belongs to the 74AHCT series. You should not exceed 140MHzin its output frequency. As a result, it consumes 2μA quiescent current and is not affected by external forces. Currently, there are 14 terminations. D latch belongs to the 74AHCT74 family. Power is supplied from a voltage of 5V volts. A JK flip flop with a 2pFfarad input capacitance is used here. This D flip flop belongs to the family of AHCT/VHCT/VT. Surface Mount mounts this electronic component. The 14pins are designed into the board. In this device, the clock edge trigger type is Positive Edge. The part is included in FF/Latches. To achieve this superior flexibility, 2 circuits are used. As a result of its reliability, this D flip flop is ideally suited for TR. It runs on 5Vvolts of power. In order to ensure high efficiency, the supply voltage should remain at 5V. Currently, there are 4 lines of input.
SN74AHCT74RGYR Features
Cut Tape (CT) package
74AHCT series
14 pins
5V power supplies
SN74AHCT74RGYR Applications
There are a lot of Texas Instruments SN74AHCT74RGYR Flip Flops applications.
- Divide a clock signal by 2 or 4
- 2 – Bit synchronous counter
- Set-reset capability
- Reduced system switching noise
- Data Synchronizers
- CMOS Process
- QML qualified product
- Dynamic threshold performance
- Common Clocks
- Bus hold
