SN74ACT574PWRG4 Overview
It is embeded in TSSOP case. There have been 20 terminations. A voltage of 5V is used as the power supply for this D latch. The electronic device belongs to the ACTfamily. Surface Mount mounts this electronic component. This board has 20 pins. It has a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. There are 8bits in this flip flop. Due to its superior flexibility, it uses 8 circuits. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. The power supply is 5V. This D flip flop is equipped with 0 ports. High efficiency requires the supply voltage to be maintained at 5V. It operates with 1 output lines. Currently, there are 3 input lines present. -24mAis the output current at high level. It is set to 24mAfor low level output current. Operating temperatures should be lower than 85°C. It is recommended that the operating temperature is higher than -40°C. The system operates with a minimum supply voltage of 4.5V. 5.5Vis its maximum supply voltage. It is possible to obtain a frequency of 110MHz. It uses BUS DRIVERas its logic IC. Currently, it is equipped with 1 functions . It has 20 pins. The 24mA output current allows it to be designed with the greatest amount of flexibility.
SN74ACT574PWRG4 Features
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
SN74ACT574PWRG4 Applications
There are a lot of Texas Instruments
SN74ACT574PWRG4 Flip Flops applications.
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
