SN74ACT534DBRG4 Overview
20-SSOP (0.209, 5.30mm Width)is the way it is packaged. D flip flop is included in the Tape & Reel (TR)package. There is a Tri-State, Invertedoutput configured with it. JK flip flop uses Positive Edgeas the trigger. There is an electrical part that is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. Currently, the operating temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. This type of FPGA is a part of the 74ACT series. You should not exceed 100MHzin the output frequency of the device. In total, there are 1 elements. As a result, it consumes 4μA of quiescent current without being affected by external factors. Terminations are 20. The 74ACT534 family contains it. A voltage of 5V is used to power it. Its input capacitance is 4.5pFfarads. In this case, the D flip flop belongs to the ACTfamily. Electronic part Surface Mountis mounted in the way. There are 20pins on it. It has a clock edge trigger type of Positive Edge. This device is part of the FF/Latchesbase part number family. There are 8bits in its design. 5.5Vis the maximum supply voltage (Vsup). Normal operation requires a supply voltage (Vsup) above 4.5V. Despite its superior flexibility, it relies on 8 circuits to achieve it. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. An electrical current of 5V volts is applied to it. A D flip flop with 2embedded ports is available. Its output current of 24mAallows for maximum design flexibility.
SN74ACT534DBRG4 Features
Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
5V power supplies
SN74ACT534DBRG4 Applications
There are a lot of Texas Instruments SN74ACT534DBRG4 Flip Flops applications.
- Event Detectors
- EMI reduction circuitry
- Registers
- ESD protection
- Latch
- Storage registers
- Synchronous counter
- Single Down Count-Control Line
- Memory
- Buffered Clock
