SN10502DG4 Overview
A SOIC case is used to package the op amp. The case in which buffer amplifier is delivered is called a Rail/Tube case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 25mV. An 14mA volt supply current is needed for this linear amplifier to operate. Voltage gain should remain at 100dB. There are 1 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. It should only be used at temperatures up above 85°C. The buffer op amp is rated for an operating voltage of 2 when it comes to the power supply. The operating supply voltage of the buffer op amp is rated at 5V. I would like to point out that this electrical component is capable of working from a voltage below 16V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 2.7V at all times. The dual supply voltage of 9V should be used for the conduct of this electronic component. Sorting based on consumer IC type can be done by using VIDEO AMPLIFIER.
SN10502DG4 Features
8 Pins
100dB voltage gain
SN10502DG4 Applications
There are a lot of Texas Instruments
SN10502DG4 Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
