OPA604AP Overview
The linear amplifier is packaged in a 8-DIP (0.300, 7.62mm) case which makes it easy for the consumer to handle. This is a General Purpose type op amp. There is a Tube case that is delivered with the instrumentation amplifiers. It is estimated that there will be 8 terminations in the next few months. A total of 8 pins are located on this board. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. In total, the buffer amplifier consists of 8 pins. There is an input offset voltage of 1mV for this buffer op amp. This electronic part is recommended for mounting type Through Hole. It is important to note that this linear amplifier works well at a temperature of -25°C~85°C when it comes to operating temperatureThe buffer amplifier is capable of operating from a supply current of 5.3mA . Maintain 100dB as the voltage gain. 1 channels are available on the instrumentation amplifier.
OPA604AP Features
8 Pins
supply voltage of 15V
100dB voltage gain
OPA604AP Applications
There are a lot of Texas Instruments OPA604AP Instrumentational OP Amps applications.
- Professional videography
- Proportional operation circuits
- Radar
- Micro signal measurement
- Medical imaging
- High-frequency data acquisition systems
- Image computer boards
- High/low-pass filter circuit
- Blood pressure sensors
- Computer workstations
