OPA4820IPWR Overview
Packaged in a 14-TSSOP (0.173, 4.40mm Width) case, the buffer op amp is ready to use. An op amp ic of the Voltage Feedback type. The op amp is delivered to you in a Tape & Reel (TR) case. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 250μV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . As long as the supply current of the chip does not exceed 22.6mA, this op amp ic can operate. 65dB should remain the voltage gain. The linear amplifier consists of 4 different elements in total. The operating supply voltage of the buffer op amp is rated at 5V. For packing the buffer amplifier, the TR-axis is adopted.
OPA4820IPWR Features
14 Pins
supply voltage of 5V
65dB voltage gain
OPA4820IPWR Applications
There are a lot of Texas Instruments
OPA4820IPWR Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
