OPA454AIDDAR Overview
There is a 8-PowerSOIC (0.154, 3.90mm Width) case package that contains the instrumentation amplifiers. An op amp ic of the General Purpose type. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. It is estimated that there will be 8 terminations in the next few months. The total number of pins on linear amplifier is 8. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 50V. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. There are 8 pins on this chip. In terms of input offset voltage, operational amplifier rates 4mV. Surface Mount is the recommended mounting type for this linear amplifier. According to the manufacturer, this buffer op amp works well at -40°C~85°C , which is a good operating temperature. This op amp can operate from a supply current at 3.2mA. Op amp is a member of the 130dB's 130dB family. Op amp has total of 1 elements. The operating supply voltage of instrumentation amplifier is rated 50V voltage. As a result of this, the buffer amplifier is packed in TR.
OPA454AIDDAR Features
8 Pins
supply voltage of 50V
130dB voltage gain
OPA454AIDDAR Applications
There are a lot of Texas Instruments OPA454AIDDAR Instrumentational OP Amps applications.
- Test equipment
- Band-pass filter
- Active probe
- Television broadcasting equipment
- Signal filtering
- Wireless base stations
- Power generator
- Inverse/same-phase proportional circuit
- ECG equipment
- Portable electronic products powered by batteries
