INA2332AIPWR Overview
Op amp is packaged in 14-TSSOP (0.173, 4.40mm Width) case. A Instrumentation-type buffer amplifier is shown here. There is a Cut Tape (CT) case that is delivered with the instrumentation amplifiers. It is estimated that there will be 14 terminations in the next few months. A total of 14 pins are located on this board. This linear amplifier should be powered by an 5V battery. In total, the buffer amplifier consists of 14 pins. Regarding input offset voltage, buffer amplifier rates 8mV voltage. For this electronic part, it is recommended that you mount it with type Surface Mount. According to the manufacturer, this buffer op amp works well at -55°C~125°C , which is a good operating temperature. You can run this op amp ic on 415μA . The voltage gain should stay at 60dB. Op amp ic has 2 channels. A benefit of this op amp ic is that it outputs Rail-to-Rail signals, which is one of the many advantages it has to offer. Depending on the chip's operating supply voltage, op amp ic has a rated voltage of 6. TR is adopted to pack the instrumentation amplifier. There is an 415μA quiescent current running through op amp ic. Instrumentation amplifier resistance should remain within the range of 10 TΩ.
INA2332AIPWR Features
14 Pins
supply voltage of 5V
60dB voltage gain
Output Type: Rail-to-Rail
Resistance of 10 TΩ
INA2332AIPWR Applications
There are a lot of Texas Instruments INA2332AIPWR Instrumentational OP Amps applications.
- pH (acidity)
- Video computer boards
- Signal filtering
- E-book readers
- Signal amplification
- Cinema or auditorium audio system
- Inverse/same-phase proportional circuit
- Thermocouples
- High/low-pass filter circuit
- Communication device
